Pasar al contenido principal

Main navigation

  • Sobre El ITEFI
  • Investigación
  • Formación y empleo
  • OpenLab
  • Servicios científico técnicos
  • Directorio

Total Focusing Method With Virtual Sources in the Presence of Unknown Geometry Interfaces

auto-focused virtual imaging - AVSI
beamforming
total focusing method - TFM
J.F. Cruza, J. Camacho
IEEE Trans. on Ultrasonics, Ferroelectrics and Frequency Control, vol. 63-10, 2016, pp. 1581 – 1592
http://dx.doi.org/10.1109/TUFFC.2016.2593439

Auto-focused virtual source imaging (AVSI) has been recently presented as an alternative method for synthetic aperture focusing through arbitrarily shaped interfaces with arrays. This paper extends the AVSI concept to the case of the total focusing method (TFM-AVSI) using several virtual receivers for each virtual source. This approach overcomes the known contrast limitation of AVSI, while preserving the advantage of performing synthetic focusing in the second medium only [no time-of-flight (TOF) calculations through the interface]. In contrast, equipment with more active channels must be used to digitalize the signals received by all the array elements after each focused emission. When compared with the conventional TFM, the proposed method reduces the processing complexity of the most time consuming task: TOF calculation in the presence of interfaces. This improvement could lead to more efficient real-time implementations of the TFM in non-destructive testing applications where water immersion or flexible wedges are used. In this paper, the mathematical formulation for the new method is given, accounting for the surface slope and the array angular sensitivity. Its performance is evaluated by numerical simulation, experimentally and compared with AVSI and the conventional TFM. It was found that the TFM-AVSI achieves the same resolution and contrast as that of the TFM, although it shows a wider blind zone below the interface due to focusing with normal incidence.

GSTU
Departamento de Acústica y Evaluación No Destructiva (DAEND)
  • GAA: Grupo de Acústica ambiental
  • G CARMA: Grupo de Caracterización de materiales mediante evaluación no destructiva
  • ULAB: Ultrasonidos para el análisis de líquidos y bioingeniería
Departamento de Tecnologías de la Información y Las Comunicaciones (DTIC)
  • GiCP: Grupo de investigación en Ciberseguridad y Protección de la Privacidad
  • GICSI: Grupo de investigación en Criptología y Seguridad de la Información
    • LCQE: Laboratorio de Comunicaciones Cuánticas
  • PSUM: Grupo de Procesamiento de Señal en sistemas Ultrasónicos Multicanal
Departamento de Sensores y Sistemas Ultrasónicos (DSSU)
  • GSTU: Grupo de Sistemas y tecnologías ultrasónicas
  • NoySI: Grupo de Nanosensores y Sistemas Inteligentes
  • RESULT: Resonadores ultrasónicos para cavitación y micromanipulación
  • SENSAVAN: Grupo de Tecnología de Sensores Avanzados
  • QE: Electrónica Cuántica
Laboratorios
  • Laboratorio de Acústica
  • Laboratorio de Metrología Ultrasónica Médica (LMUM)
  • Laboratorio de Comunicaciones Cuánticas
  • Laboratory for International Collaboration in Advanced Biophotonics Imaging

Instituto de Tecnologías Físicas y de la Información Leonardo Torres Quevedo  - ITEFI
C/ Serrano, 144. 28006 - Madrid • Tel.: (+34) 91 561 88 06  Contacto  •  Intranet
EDIFICIO PARCIALMENTE ACCESIBLE POR PERSONAS CON MOVILIDAD REDUCIDA