Pasar al contenido principal

Main navigation

  • Sobre El ITEFI
  • Investigación
  • Formación y empleo
  • OpenLab
  • Servicios científico técnicos
  • Directorio

The Effect of a Micro-Perforated Cavity Floor on the Propagation of Tunnel-Cavity Modes in a Low-Speed Duct Flow

C. Maury, T. Bravo and D. Mazzoni

FORUM ACUSTICUM 2020, FA2020/35,

E-congress celebrado del 7 al 11 de diciembre de 2020, Lyon, Francia.

Experimental and numerical studies are presented that show how transverse Tunnel-Cavity (TC) modes are nearly trapped and attenuated by a non-symmetric shallow cavity whose base wall is micro-perforated and that undergoes a low-speed flow regime at Mach 0.09. Three effects are pointed out. First, wall-pressure measurements and 2D LBM (Lattice-Boltzmann Method) simulations confirmed the potential of micro-perforated cavity floors to attenuate the transverse cut-on TC modes that are cut-off in the tunnel section and excited by the shear layer, albeit overestimated in the 2D simulations. LBM simulations show that the maximum velocity fluctuations occur within, but also at the inlet/outlet of the micro-perforations through vortex shedding. The latter mechanism appears to play a more important role in the attenuation than visco-thermal dissipation, given a Shear number comprised between 2.9 and 5.1 up to 1 kHz. Second, elasto-acoustic coupling was observed between the transverse TC resonances and the flexural modes of the thin micro-perforated panel, that causes a downshift of the first TC-Panel resonance frequencies with respect to the uncoupled TC resonances. Third, an optimisation study has been carried out on the micro-perforated panel (MPP) parameters for the MPP input impedance to achieve maximum axial decay rate of the least attenuated TC mode at its resonance frequency. Although this mode was already attenuated by the nominal MPP, simulations showed that replacing the cavity floor by an optimized MPP provides further broadband reduction in the region of the plane wave least attenuated mode below the first TC cut-on frequency. However, this effect is limited to the spatial extent where the axial mean flow velocity takes the value assumed in the optimisation process.

 

Conferencia invitada
Comunicación presentada (800.18 KB)
GAA
Teresa Bravo María

proyecto/s relacionado/s

  • Absorción acústica cuasi-perfecta en banda ancha con metamateriales bio-inspirados para los sistemas de transporte terrestres y aéreos
    Plan Estatal de Investigación Científica y Técnica y de Innovación 2013-2016, Programa Estatal de I+D+i Orientada a los Retos de la Sociedad (AEI), Fondos Feder
Departamento de Acústica y Evaluación No Destructiva (DAEND)
  • GAA: Grupo de Acústica ambiental
  • G CARMA: Grupo de Caracterización de materiales mediante evaluación no destructiva
  • ULAB: Ultrasonidos para el análisis de líquidos y bioingeniería
Departamento de Tecnologías de la Información y Las Comunicaciones (DTIC)
  • GiCP: Grupo de investigación en Ciberseguridad y Protección de la Privacidad
  • GICSI: Grupo de investigación en Criptología y Seguridad de la Información
    • LCQE: Laboratorio de Comunicaciones Cuánticas
  • PSUM: Grupo de Procesamiento de Señal en sistemas Ultrasónicos Multicanal
Departamento de Sensores y Sistemas Ultrasónicos (DSSU)
  • GSTU: Grupo de Sistemas y tecnologías ultrasónicas
  • NoySI: Grupo de Nanosensores y Sistemas Inteligentes
  • RESULT: Resonadores ultrasónicos para cavitación y micromanipulación
  • SENSAVAN: Grupo de Tecnología de Sensores Avanzados
  • QE: Electrónica Cuántica
Laboratorios
  • Laboratorio de Acústica
  • Laboratorio de Metrología Ultrasónica Médica (LMUM)
  • Laboratorio de Comunicaciones Cuánticas
  • Laboratory for International Collaboration in Advanced Biophotonics Imaging

Instituto de Tecnologías Físicas y de la Información Leonardo Torres Quevedo  - ITEFI
C/ Serrano, 144. 28006 - Madrid • Tel.: (+34) 91 561 88 06  Contacto  •  Intranet
EDIFICIO PARCIALMENTE ACCESIBLE POR PERSONAS CON MOVILIDAD REDUCIDA