Skip to main content

Main navigation

  • About ITEFI
  • Research
  • Formación y empleo
  • OpenLab
  • Servicios científico técnicos
  • Staff Directory

Auto-focused virtual source imaging with arbitrarily shaped interfaces

J. Camacho, J.F. Cruza
IEEE Trans. on Ultrasonics, Ferroelectrics and Frequency Control, vol. 62, 11, 2015, pp. 1944-1956.
http://doi.org/10.1109/TUFFC.2015.007092

This work presents a new method, named autofocused virtual source imaging (AVSI), for synthetic aperture focusing through arbitrarily shaped interfaces with arrays. First, the shape of the component surface is obtained by timeof- flight (TOF) measurements. Then, a set of virtual source/ receivers is created by focusing several array subapertures at the interface normal incidence points. Finally, the synthetic aperture focusing technique (SAFT) is applied to the received signals to generate a high-resolution image. The AVSI method provides several advantages for ultrasonic imaging in a twomedia scenario. First, knowledge of the probe-part geometry is not required, because all information needed for image formation is obtained from a set of ultrasonic measurements. Second, refraction complications in TOF calculations are avoided, because foci at the interface can be considered as virtual source/ receivers, and SAFT can be performed in the second medium only. Third, the signal-to-noise ratio is higher than with synthetic aperture techniques that use a single element as emitter, and fourth, resolution is higher than that obtained by phasedarray imaging with the same number of active elements, which reduces hardware complexity. The theoretical bases of the method are given, and its performance is evaluated by simulation. Finally, experimental results showing good agreement with theory are presented.

GSTU
Acoustics and Non Destructive Evaluation (DAEND)
  • Environmental Acoustics (GAA)
  • G Carma: Materials Characterization by Non Destructive Evaluation
  • ULAB, Ultrasounds for Liquid Analysis and Bioengineering
Information and Communication Technologies (TIC)
  • Cybersecurity and Privacy Protection Research Group (GiCP)
  • Research group on Cryptology and Information Security (GiCSI)
    • Quantum Communications Laboratory (LCQE)
  • Multichannel Ultrasonic Signal Processing Group (MUSP)
Sensors and Ultrasonic Systems (DSSU)
  • Ultrasonic Systems and Technologies (USTG)
  • Nanosensors and Smart Systems (NoySi)
  • Ultrasonic Resonators for cavitation and micromanipulation (RESULT)
  • Advanced Sensor Technology (SENSAVAN)
  • Quantum Electronics (QE)
Laboratorios
  • Laboratorio de Acústica
  • Laboratorio de Metrología Ultrasónica Médica (LMUM)
  • Laboratorio de Comunicaciones Cuánticas
  • Laboratory for International Collaboration in Advanced Biophotonics Imaging

Instituto de Tecnologías Físicas y de la Información Leonardo Torres Quevedo  - ITEFI
C/ Serrano, 144. 28006 - Madrid • Tel.: (+34) 91 561 88 06  Contacto  •  Intranet
EDIFICIO PARCIALMENTE ACCESIBLE POR PERSONAS CON MOVILIDAD REDUCIDA