Skip to main content

Main navigation

  • About ITEFI
  • Research
  • Formación y empleo
  • OpenLab
  • Servicios científico técnicos
  • Staff Directory

Ultrasound imaging of immersed plates using high-order Lamb modes at their low attenuation frequency bands

Lamb waves
ultrasonic array
imaging
immersed plate
attenuation
Takiy, A.E.; Kitano, C.; Higuti, R.T.; Granja, S.C.G.; Prado, V.T.; Elvira, L.; Martínez-Graullera, O.
Mechanical Systems and Signal Processing, Vol. 96, pp. 321-332, Academic Press.
http://dx.doi.org/10.1016/j.ymssp.2017.04.021

This paper focuses on the use of a Lamb wave-based methodology for ultrasound imaging of immersed plate structures. In these cases Lamb waves can be strongly attenuated due to leaky waves and viscous losses in the liquid, but there are low attenuation frequency bands that may be used for NDT applications. Experimental measurements were conducted to validate the existence of these low attenuation frequency bands, which were also theoretically predicted for some propagation modes, between the frequencies-thickness products of 0.5 MHz mm and 9.0 MHz mm. Using a 5 MHz linear-array and phased-array techniques, A1 and S1 modes are used to obtain images of an immersed aluminum plate with artificial defects. The signals are post-processed in order to select the desired propagation mode and to obtain an image with dynamic focusing in reception. While the A1 mode is strongly attenuated, the S1 mode, at 3.4 MHz mm, can be used to detect and localize defects in the immersed plate.

Acknowledgements

The authors would like to thank the funding agencies: CAPES – Brazil, CNPq – Brazil (560825/2010-2) and FAPESP – Brazil (2014/08790-3); MINECO – Spain (PIB2010BZ-00570); and Professor Julio C. Adamowski, from USP - São Paulo University, for providing the 5 MHz wideband transducers.

ULAB
PSUM
Acoustics and Non Destructive Evaluation (DAEND)
  • Environmental Acoustics (GAA)
  • G Carma: Materials Characterization by Non Destructive Evaluation
  • ULAB, Ultrasounds for Liquid Analysis and Bioengineering
Information and Communication Technologies (TIC)
  • Cybersecurity and Privacy Protection Research Group (GiCP)
  • Research group on Cryptology and Information Security (GiCSI)
    • Quantum Communications Laboratory (LCQE)
  • Multichannel Ultrasonic Signal Processing Group (MUSP)
Sensors and Ultrasonic Systems (DSSU)
  • Ultrasonic Systems and Technologies (USTG)
  • Nanosensors and Smart Systems (NoySi)
  • Ultrasonic Resonators for cavitation and micromanipulation (RESULT)
  • Advanced Sensor Technology (SENSAVAN)
  • Quantum Electronics (QE)
Laboratorios
  • Laboratorio de Acústica
  • Laboratorio de Metrología Ultrasónica Médica (LMUM)
  • Laboratorio de Comunicaciones Cuánticas
  • Laboratory for International Collaboration in Advanced Biophotonics Imaging

Instituto de Tecnologías Físicas y de la Información Leonardo Torres Quevedo  - ITEFI
C/ Serrano, 144. 28006 - Madrid • Tel.: (+34) 91 561 88 06  Contacto  •  Intranet
EDIFICIO PARCIALMENTE ACCESIBLE POR PERSONAS CON MOVILIDAD REDUCIDA